Directions of Vector

While we Study vector we have certain privileges (Humara Haq) We call it " Aazadi Ka Neeyam "
  1. We can never change the direction unless we are told in the question to do so.
  2. We can displace the vector in any direction keeping its angle fixed (i.e again direction)
Above two will be more clear with some illustrations.

Vectors can be directed due East, due West, due South, and due North. But some vectors are directed northeast (at a 45 degree angle); and some vectors are even directed northeast, yet more north than east. Thus, there is a clear need for some form of a convention for identifying the direction of a vector that is not due East, due West, due South, or due North. There are a variety of conventions for describing the direction of any vector. The two conventions that will be discussed and used in this unit are described below:

  1. The direction of a vector is often expressed as an angle of rotation of the vector about its "tail" from east, west, north, or south. For example, a vector can be said to have a direction of 40 degrees North of West (meaning a vector pointing West has been rotated 40 degrees towards the northerly direction) of 65 degrees East of South (meaning a vector pointing South has been rotated 65 degrees towards the easterly direction).
  2. The direction of a vector is often expressed as a counterclockwise angle of rotation of the vector about its "tail" from due East. Using this convention, a vector with a direction of 30 degrees is a vector that has been rotated 30 degrees in a counterclockwise direction relative to due east. A vector with a direction of 160 degrees is a vector that has been rotated 160 degrees in a counterclockwise direction relative to due east. A vector with a direction of 270 degrees is a vector that has been rotated 270 degrees in a counterclockwise direction relative to due east. This is one of the most common conventions for the direction of a vector and will be utilized throughout this unit.

 

Comments

Post a Comment

Popular posts from this blog

Rolling Motion made Easy

Image
Q. Many of us we think that Rolling Motion is tough? The answer to the above question is "BIG NO" things are only tough till you understand them completely. So, I am here to guide you on the above topic. Leave comments on any Doubts faced by you recently. When we talk about pure Rotational Motion we imagine a fixed axis about which the all the particles of the Rigid Body are moving in a Circular Motion. Hence if the body moves with angular Velocity ' omega ' (w) than every particle on the periphery will have linear velocity as v =wr ( where r is the radius of the particle from its axis ). In the above Diagram we see 3 figures: 1st figure shows when the body is in pure translational motion only, every particle of the rigid body will have same velocity ( same Direction ) as visible. 2nd figure shows when the body is in pure rotational motion as discussed above particle will have same speed but different velocity about fixed axis O. 3rd figure sh
Read more

Factors affecting of resistances, Combination Of Series and Paralell

Image
 Electric resistance of a conductor (or a wire) depends on the following factors Length of the conductor: - Resistance of a conductor is directly proportional to its length. So, when length of the wire is doubled, its resistance also gets doubled; and if length of the wire is halved its resistance also gets halved. Thus a long wire has more resistance then a short wire. Area of cross-section:- Resistance of a conductor is inversely proportional to its area of cross-section. So, when the area of cross-section of a wire is doubled, its resistance gets halved; and if the area of cross-section of wire is halved then its resistance will get doubled. Thus a thick wire has less resistance and a thin wire has more resistance. 3. Nature of material of conductor:- Electrical resistance of a conductor also depends on the nature of the material of which it is made. For example a copper wire has less resistance then a nichrome wire of same length and area of cross-section. 4
Read more